LMS-SPADA INDONESIA
Penugasan
Tugas Kelas 4
Syarat penyelesaian
Opened: Senin, 18 Mei 2020, 23:00
Due: Selasa, 19 Mei 2020, 01:00
Dikerjakan secara mandiri dengan waktu 3*50 menit
Guys, please, answer the questions below:
#2 Make a detailed drawing of the spindle shown in Fig. below. Scale the part for sizes using one of the scales shown with the drawing. Other considerations are:
Guys, please, answer the questions below:
#1 Calculate the sizes and tolerances for one of the drawings shown in Fig.
#2 Make a detailed drawing of the spindle shown in Fig. below. Scale the part for sizes using one of the scales shown with the drawing. Other considerations are:
a. "A" diameter to have an LC3 (inch) or H7 /h6 (metric) fit.
b. "B" diameter requires a 96 diamond knurl or its equivalent.
c. "C" diameter to have an LT3 (inch) or H7 /k6 (metric) fit.
d. "D" diameter to be a minimum relief (undercut).
e. "E" to be a standard No. 807 Woodruff key in the center of the segment and the diameter to be controlled by an RC3 (inch) or H7 /g6 (metric) fit.
f. "F' to be undercut for a standard external retaining ring and dimensioned to manufacturer's specifications.
g. Dimension in decimal inch or metric.
LMS-SPADA INDONESIA